Flex CHE 2-28 R SDS-plus Instruction Manual page 16

CHE 2-28 R SDS-plus
 Insert insertion tool (1.) and turn (2.)
it until it locks.
 Check lock by pulling on the insertion
tool.
Removing the tools
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
CAUTION!
Used insertion tools may become hot.
Wear protective gloves!
 Pull locking sleeve backwards (1.).
 Remove insertion tool (2.).
Setting operating mode
CAUTION!
Do not change operating mode until the
electric power tool is at a standstill.
 Press release button.
 Setting rotary knob to the required
operating mode:
Drilling
Hammer drilling
Setting the chisel position
(see below)
Chiselling
NOTE!
– The release button must visibly lock
(jump out) in the
(hammer drilling) and
positions.
– Do not switch on the electric power tool
in the position
position).
Setting the chisel position
The chisel can be turned to a position which
is ideal for the work to be performed.
 Press release button and move rotary knob
for operating mode to the symbol
 Turn chisel until the chisel is at the
required angle (2.).
 Press release button and move rotary knob
for operating mode to the symbol
Ensure button is locked!
(drilling),
(chiselling)
(setting the chisel
(1.).
.
17