Epson EMP 51/L User Manual page 25

note
If your projected image seems
distorted, you may need to
change your aspect ratio.
Generally, (for wide
16.9
screen) is the correct setting.
Setting Up the Projector
20
Before you start, make sure the projector and your component video
source are turned off.
1. Connect the red and white plugs on the A/V cable to the
projector's
Audio L
component video cable
(not included)
RCA
audio/video cable
2. Connect the red and white plugs at the other end of the A/V cable
to the corresponding audio output jacks on your video source.
3. Connect the 15-pin connector on the component video cable to
the projector's computer port.
4. Connect the green, blue, and red jacks on the other end of the
cable to these ports on your component video source:
(green)
I
Y
I or (blue)
Pb Cb
or (red) port.
I
Pr Cr
5. Select the correct settings for your component video source in the
projector's Video menu (as described on page 42):
If you connected the projector to a DVD player, select
I
as the Input Signal setting.
YCbCr
If you connected an HDTV source or if your DVD player
I
supports YPbPr, select
(white) and (red) jacks.
R
as the Input Signal setting.
YPbPr