Table of Contents
Advertisement
en Installation instructions
Slide the fan box into the guide, connect the pipe-
6.
work and screw the fan box tightly back in place.
Support the appliance from below and remove the
7.
slats.
Insert the appliance fully in the cut-out.
8.
Align the rails to the bottom and attach to the
9.
side .
Screw the rails onto the bottom of the unit.
10.
Note: If an appliance with the dimension 90 cm is
11.
installed in a unit with a width of 90 cm, skip the
next two installation steps and follow the instructions
in the additional accessory pack.
Screw in the screw from below and tighten the nut.
20
Align the appliance to the hob and tension it
12.
against the worktop .
Insert the drip tray and snap it into place.
13.
Plug the cables into the fan box.
14.
Carefully insert the glass pane as far as it will go
15.
into the guides.
Connect the appliance to the power supply.
16.
a The glass panel moves downwards and the appli-
ance closes.
Insert the grease filters.
17.
→ "Fitting the grease filters", Page 11
Advertisement
Table of Contents
