Table of Contents
Advertisement
x
b. ATTACHING THE GUARD
Remove the battery pack. Invert the grass trimmer/edger to access the trimmer head.
Remove the pre-installed screw from the trimmer head.
Place the guard on to the trimmer head so that the large part of the guard sits to the rear,
Fig.3.
Align the screw hole on the guard with the screw hole on the trimmer head. Insert the screw
into the trimmer head, fastening the guard in place. Fig.4.
Remove the protective tape from the line cutting blade, Fig.5.
c. ADJUSTING THE AUXILIARY HANDLE
To avoid injury, adjust the auxiliary handle for optimum control and balance. Do not
overreach when operating grass trimmer/edger. Keep proper balance at all times for better
control of the tool in unexpected situations.
The auxiliary handle can be moved either up and down the shaft, forward and backwards
or rotated 36C0 around the shaft. To find your optimum desired position unlock the assist
handle locking lever by pulling outwards, Fig.6. Once you have the desired position relock
the assist handle locking lever by pushing inwards.
d. ADJUSTING THE SHAFT LENGTH
Loosen the lower part of the centre collar (Fig.7). This will allow the lower part of the shaft
to be extended or retracted. When the shaft is at a comfortable length, retighten the collar.
12
Advertisement
Table of Contents
