Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Glow-worm Compact 28c-AS/1
Summary of Contents for Glow-worm Compact 28c-AS/1
- Page 1 Compact 24c-AS/1, 28c-AS/1 en Operating instructions...
-
Page 2: Table Of Contents
Operating instructions Guarantee and customer service ........11 Contents 11.1 Guarantee........11 11.2 Customer service......11 Safety ..........3 Appendix ..........12 Intended use ........3 Eliminating faults....... 12 Qualification ........3 Troubleshooting ......12 General safety information..... 3 Notes on the documentation ..6 Benchmark........ -
Page 3: Safety
1 Safety experience and knowledge if they have been given supervi- 1.1 Intended use sion or instruction concerning The product is intended as a use of the product in a safe way heat generator for sealed heat- and understand the hazards in- ing installations and for do- volved. - Page 4 ▶ Do not use any electrical ▶ Do not damage or remove switches, mains plugs, door- any tamper-proof seals on bells, telephones or other components. ▶ Do not make any changes: communication systems in the building. – The product itself ▶...
- Page 5 ▶ Only fill the heating installa- tion with suitable heating wa- ter and, in cases of doubt, ask a competent person about this. 0020313974_00 Compact Operating instructions...
-
Page 6: Notes On The Documentation
▶ Store these instructions and all other applicable documents for further use. Glow-worm is a licensed member of the Benchmark Scheme which aims to im- These instructions apply for the following prove the standards of installation and products only:... -
Page 7: Displayed Symbols
4.3 Data plate Control Operation element The data plate is mounted on the rear of – Switch the product on/off the electronics box and on the upper side – Activate/deactivate standby of the product at the factory. mode – Go back one level 4.4 Serial number You can find the serial number on the data –... -
Page 8: Setting The Heating Flow Temperature
– oF indicates that heating mode is for longer than two minutes. The display either shows the target flow temperature switched off. ▶ (if no control is connected) or the message If oF is shown in the display, press the on and/or oF (if a control is connected). -
Page 9: Care And Maintenance
◁ The target domestic hot water tem- Note perature is displayed. If the heating installation ex- tends over several storeys, a Condition: Control connected higher filling pressure may be ▶ Switch off heating mode on the control required for the heating install- (→... -
Page 10: Checking The Condensate Discharge Pipe And Tundish
7.1 Eliminating faults Note A purging key can be used for – If one or more faults occur, the basic the purging. display switches between the active fault code(s) and the target heating flow 7. Check the system pressure after pur- temperature. -
Page 11: Permanently Decommissioning The Product
For contact details for our customer ser- vice department, you can write to the ad- dress that is provided on the back page, or 10 Recycling and disposal you can visit www.glow-worm.co.uk. ▶ The competent person who installed your product is responsible for the dis- posal of the packaging. -
Page 12: Appendix
Appendix A Eliminating faults Code/meaning Possible cause Measure F.22 Water deficiency in 1. Check the filling pressure of the heating the heating installation installation. (→ Page 9) System pressure too 2. Fill the heating installation. (→ Page 9) F.28 After three unsuc- 1. - Page 16 Nottingham Road Belper-Derbyshire DE56 1JQ Telephone 01773 824639 Technical helpline 0330 100 7679 After sales service 0330 100 3142 www.glow-worm.co.uk © These instructions, or parts thereof, are protected by copyright and may be reproduced or distributed only with the manufacturer's written consent. Subject to technical modifications.
Need help?
Do you have a question about the Compact 28c-AS/1 and is the answer not in the manual?
Questions and answers