Camera Setup; Camera Functions - Uniq UC-900CL User Manual

2. Camera Setup

A basic camera and frame grabber system setup, as shown in Figure 1 below, requires a
UC-900CL camera, a standard C-mount lens, a PS-12C power supply or equivalent,
a PC system and a VGA monitor, a frame grabber, and an external trigger device if necessary.

3. Camera Functions

3.1 12-Pin Connector
The 12-pin Hirose connector is located on the
rear panel of the camera. All ground signals
on pin 1, 3, 5, and 8 are common grounds.
+12 V DC input is recommended on pin 2, but
this camera should withstand +12 V ± 1V
input voltage. Make sure to set the NM/AM
switch to NM position for external HD and VD
locking. Figure 2 below shows a top view of
the 12-pin Hirose connector.
Figure 1. Camera and Frame Grabber System Setup
Pin No.
1
2
3
4
5
6
7
8
9
10
11
12
Figure 2. 12-Pin Hirose Connector
5
UC-900CL
GND
+12V DC input
GND
Video
GND
N/C
N/C
GND
N/C
N/C
Integration control
N/C