Outside Top Exhaust (Vertical Duct); A1. Attach The Mounting Plate To The Wall; A2. Use Top Cabinet Template For Preparation Of Top Cabinet - Samsung ME17R7021EW/AC Installation Instructions Manual

Step-by-step installation guide
A. OUTSIDE TOP EXHAUST (VERTICAL DUCT)
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Mount the Microwave Oven
A4. Adjust the Exhaust Adaptor
A5. Connecting Ductwork
A1. ATTACH THE MOUNTING PLATE TO THE
WALL
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to a
wall stud.
1. Remove the toggle wings from the bolts.
2. Insert the bolts into the mounting plate through
the holes designated to go into drywall, and then
reattach the toggle wings to ¾˝ onto each bolt.
To use toggle bolts:
Spacing for Toggles More
Spacing for Toggles More
Than Wall Thickness
Than Wall Thickness
Toggle Wings Toggle Wings
Mounting
Mounting
Toggle
Toggle
Plate
Plate
Bolt Bolt
Wall Wall
3. Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
OTR_II_DE68-03587B-07_EN+CFR.indb 12 OTR_II_DE68-03587B-07_EN+CFR.indb 12
Bolt End
Bolt End
12
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed flush against the
wall and that the plate is properly centered under the
cabinet.
CAUTION: Be careful to avoid pinching your fingers
between the back of the mounting plate and the wall.
4. Tighten all bolts. Pull the plate away from the wall to
help tighten the bolts.
A2. USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws, a hole
large enough for the power cord to fit through, and a
cutout large enough for the exhaust adaptor.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes in
the cabinet bottom.
2022-01-20 2022-01-20 10:11:53 10:11:53