Table of Contents
Advertisement
8.
DIMENSIONS
158 mm
Figure 12: LINETROLL 110Tµ/110Tµr physical
dimensions. All figures in mm.
9. MOUNTING.
LINETROLL 110E mounts directly on the
high voltage conductor using a shotgun type
Hot-stick as shown in fig 14. It should be
mounted as close as possible to a traverse to
escape line vibrations.
Figure 14Hot-stick mounting, - close to the traverse
To fully cover all kinds of faults,
NORTROLL recommend mounting
indicators on all the phases in multi-phase
networks. Locate the indicators at strategic
points along the line.
9.1 Before mounting.
Make sure the indicator is programmed (see
4.7 Programming) and battery connected
before mounting on the line.
LineTro110Tµr User Guide
9.2 Live-line mounting by using a Grip-
All-Clamp (shot-gun) Hot-Stick:
1.
Fix the indicator to the hot-stick
and raise/lift it to the line as shown in
fig 14.
2.
Pull the stick downwards and
against the line, until the line is in the
correct position within the clamp, see
fig 15.
Release the Grip-All-Clamp stick.
Figure 15: Mounting using Grip-All clamp hot stick
9.3 Removal.
1. Fix the claw in the "eye" on the
horizontal part of the line-clamp, see
fig 15.
2. Pull down, to release the indicator
from the line.
Figure 16: Removal from the line.
June 2011
Page 13 of 16
Advertisement
Table of Contents
