Table of Contents
Advertisement
Test of the battery.
Battery can be tested by placing a magnet on
the yellow spot marked: RESET.
After 2 sec the indicator will respond by
flashing all the LED's, see section 10.
Flashing sequences -Test/Reset.
During the last few months of the battery's
life, an amber/yellow LED with a low
flashing frequency (1/10 Hz) will indicate
that less than 20% of battery capacity
remains and that there is a need for a battery
replacement.
The LT-110Tµr will in addition, transmit a
"Low-Battery" message to the Collector.
Programming.
Open the indicator by unscrewing the top-
cap from the lens. See Figure 17.
LineTro110Tµr User Guide
Pull out the electronics board just as far as to
enable operation of the switch-bank levers.
See Feil! Fant ikke referansekilden. 18.
Set the switches as required. Push the
electronics board back into position.
Align the top-cap arrow with the lens label
arrow before closing the unit. See section
4.7 for programming instructions.
Figure 17: Opening/ closing the LINETROLL 110Tµ.
June 2011
Page 14 of 16
Advertisement
Table of Contents
