Table of Contents
Advertisement
8.
DIMENSIONS
158 mm
Figure 12: LINETROLL 110Eµ/110Eµr physical
dimensions. All figures in mm.
9. MOUNTING.
LINETROLL 110E mounts directly on
the high voltage conductor using a Hot-
stick as shown in fig 14. It should be
mounted as close as possible to a traverse
to escape line vibrations.
Figure 14Hot-stick mounting, - close to the traverse
To fully cover all kinds of faults,
NORTROLL recommend to mount
indicators on all the phases in multi-phase
networks. Locate the indicators at strategic
points along the line.
9.1 Before mounting.
Make sure the indicator is programmed
(see 4.7 Programming) and battery
connected before mounting on the line.
LINETROLL 110E /110Eµr User Guide February 2010
9.2 Live-line mounting by using a
Grip-All-Clamp (shot-gun) Hot-Stick:
1.
Fix the indicator to the hot-stick
and raise/lift it to the line as shown
in fig 14.
2.
Pull the stick downwards and
against the line, until the line is in
correct position, see fig 15.
Release the grip-all stick.
Figure 15: Mounting & Grip-All_clamp hot stick
9.3 Removal.
1. Fix the claw in the "eye" on the
horizontal part of the line-clamp,
see fig 15.
Pull down, to release the indicator
2.
from the line.
Figure 16: Removal from the line.
Page 13 of 16
Advertisement
Table of Contents
