Advertisement
Installation Safety Pins
The Swivel Hook Trailer Spotters are very easily installed by inserting your
forklift tines fully into the pockets so the ears extend behind the Forks. Then
install the safety retainer pin behind the fork and insert the security clip. (
As Shown on the diagram) The safety retainer pins are chained to the Jib to
prevent loss of the pins. These must be properly installed and secured before
using the Jib. Note: Swivel Hook Frame, Hook and retainer pins should be
fully inspected before every use.
- Operating Rules for Swivel Hook Trailer Spotters -
Inspection
1. Check the Swivel Hook, Latch, Bolt and Sleeve making sure that it is properly installed and in
good working condition.
2. Check the Bolt and sleeve for any wear or distortion
3. Safety pins must be installed and secured with the cotter pin.
4. Check the Swivel Hook Frame for any excessive wear, cracked or broken welds.
5. Check each of the holes for any elongation.
6. Check the receiver hitch and make it free from defects and is properly pinned.
7. The Swivel Hooks load capacity rating and empty weight decals must be present and legable.
8. The operator must have read and understands the operators manual.
Installing on a Lift Truck
1. Secure the safety pins behind the heel of each fork.
2. Optional Safety chains when used are only to be used in addition to the safety retainer pins, not
in lieu of.
3. Disable any hydraulic functions to the Forklift Carriage. Such as tilting or swinging functions.
4. Position the fork tines so that the Swivel Hook Trailer Spotter will hold the load centered on the
Forklift.
Marv Haugen Enterprises * 1851 Heartland Ave * Casselton ND 58012
Marv Haugen Enterprises
1851 Heartland Ave. - Casselton, ND 58012
Toll Free 877-580-6218
Phone: 701-347-4827 Fax: 701-347-4830
Phone: 877-580-6218
Advertisement
