Contents Your 3-in-1: air purifier, fan and heater ������������������������������������2 Product overview ....................... 2 Display overview ......................3 Controls overview ......................4 Getting started ������������������������������������������������������������������������������5 Installing the filter ...................... 5 Setting up the remote control ................5 Using the 3-in-1: air purifier, fan and heater ���������������������������5 Air quality light ......................
Your 3-in-1: air purifier, fan and heater Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Product overview Remote control Display screen Housing Philips filter (FYM220/30) Control buttons...
Getting started Installing the filter Note: Make sure the appliance is unplugged from the electrical outlet before installing the filter. To remove the back cover, hold the side of it with both hands and pull. Pull the filter from the appliance. Remove all packaging materials from the filter.
Turning on and off Note: • Plug the appliance into the power outlet; do not use a power strip. • If the appliance is running in heating mode when you turn it off, it continues working for 20 seconds to exhaust the remaining heat. Counting down will show on the display panel.
Sleep, turning light on/off Press and hold the button for 3 seconds. » The display screen dims, rest lights will turn off. Press any button to turn all lights on. Pairing your remote control Unplug the appliance from the power outlet and wait for 10 seconds. Plug in the appliance, then within 5 seconds,press the button on the appliance twice.
• Do not smell the filter because it contains air pollutants. Replace the filter when lights up on the screen. Replace the filter with Philips filter (FYM220/30). Follow the instructions in the chapter “Installing the filter”. Press to switch on the appliance.
Press and hold the button for 3 seconds to reset the filter replacement time. » The filter replacement alert disappears from the screen. Wash your hands thoroughly after replacing the filter. Before the filter replacement alert lights up You can replace the filter before the filter replacement alert ( ) lights up.
If nothing is found, please contact your Philips dealer or an authorized Philips service center. • The filter may produce an odor after being used for a while because of the absorption of indoor gases.
Information requirements for electric local space heaters Model identifier(s): AMF220 Item Symbol Value Unit Item Unit Heat output Type of heat input, for electric storage local space heaters only (select one) Nominal heat output manual heat charge control, with [no] integrated thermostat Minimum heat output manual heat charge control with room...