Tcp Server Usage - Ebyte E90-DTU-V8 User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.
E90-DTU(433L30E)-V8 User Manual
Step 3: Use "Ebyte Network Configuration Tool" or web page configuration;
Step 4: Configure the wireless parameters as shown in the figure above, the host computer clicks "Save
Configuration" and then clicks "Restart Device", click Submit for the web page configuration, enter the
configuration key: 123456, and wait for the configuration to complete;
【Note】
 For browsers that do not support IE kernel, you can use Firefox, GOOGLE, the latest Edge and other browsers;
 If the host computer fails to search for the device, first check whether the network cable is connected normally,
and check whether the host computer is turned on for many times in the local area network. If it still cannot be
used normally, you can close the firewall and restart the host computer;
 Do not enter the web page in communication mode, otherwise the device will enter the configuration mode,
and you can only exit the configuration mode by submitting data or restarting the device.

2.5. TCP server usage

Configure the Ethernet parameters of the "gateway radio", the host computer and web page are configured as
follows:
The network assistant (NetAssist) is connected to the "gateway radio" as shown in the figure below (the LINK
indicator of the device is always on after the connection is successful, if it can be connected but the indicator is not
on, the device is in configuration mode, which can be released by restarting the device), XCOM is connected to the
"serial gateway" ":
Copyright ©2012–2022,Chengdu Ebyte Electronic Technology Co.,Ltd.
6