Advertisement
TSB 2013.07.001 : Changing Roller Arm Positions: "N-Series" Spring Reels
Changing Roller Position from
1. Check if the arm holding the roller assembly to the frame is the same as in Figure 14. If you don't have
the same arm you must order p/n 9941.0031.
Figure 13 - Old Style Roller Arm (9941.0030)
2. Remove spring per Hannay TSB
2013.06.003 Changing a Hannay
Spring Motor, this can be found at
www.hannay.com. The reel should
look like Figure 15.
3. Remove the nuts and bolts holding
the roller arms to the frame.
4. Move the Roller Arms to the "TR"
position (Figure 16). On the back
side of the reel, align the holes and
install the bolts.
5. Rotate the roller assembly so that is
it pointed in the same direction as
shown in Figure 16.
6. Check that all bolts and nuts are
tight.
7. Replace the spring per Hannay TSB
2013.06.003 Changing a Hannay
Spring Motor.
8. To go from a "TR" to an "SR" simply
reverse steps 1 – 8, discarding the
two new bolts from step 5.
PDF 1-20
"SR" to "TR"
with a "C or L" Spring:
Figure 14 - New Style Roller Arm (9941.0031)
Figure 15 - Reel with Rollers in the "SR" Position
Figure 16 - Reel with Rollers in the "VR" Position
7 of 7
Models Built after October 2013
Form H-1305-TSB Rev 1
Advertisement
