Advertisement
TSB 2013.07.001 : Changing Roller Arm Positions: "N-Series" Spring Reels
Changing Roller Position from
1. Check if the arm holding the roller assembly to the frame is the same as in Figure 10. If you don't have
the same arm you must order p/n 9941.0031.
Figure 9 - Old Style Roller Arm (9941.0030)
2. Remove spring per Hannay TSB
2013.06.003 Changing a Hannay
Spring Motor, this can be found at
www.hannay.com. The reel should
look like Figure 11.
3. Remove the nuts and bolts holding
the roller arms to the frame.
4. Swing the Roller Bracket up to the
VR position (Figure 12) until the
holes on the roller arms line up with
the holes in the frame. Replace and
tighten the bolts.
5. Remove the bottom bolts attaching
the roller assembly to the roller
arms and loosen the top bolts.
6. Rotate the roller assembly so that is
it pointed in the same direction as
shown in Figure 12.
7. Check that all bolts and nuts are
tight.
8. Replace the spring per Hannay TSB
2013.06.003 Changing a Hannay
Spring Motor.
9. To go from a "VR" to an "SR" simply
reverse steps 1 – 8.
PDF 1-20
"SR" to "VR"
with a "C or L" Spring:
Figure 10 - New Style Roller Arm (9941.0031)
Figure 11 - Reel with Rollers in the "SR" Position
Figure 12 - Reel with Rollers in the "VR" Position
6 of 7
Models Built after October 2013
Form H-1305-TSB Rev 1
Advertisement
