Advertisement
TSB 2013.07.001 : Changing Roller Arm Positions: "N-Series" Spring Reels
Changing Roller Position from
1. Remove spring per Hannay TSB
2013.06.003 Changing a Hannay
Spring Motor, this can be found
at www.hannay.com. The reel
should look like Figure 7.
2. Make note of the spring bracket
mounting location it can be
reinstalled later.
3. Remove the 3/8" nuts and bolts
holding the spring mounting
bracket and roller arms to the
frame.
4. Move the Roller Arms to the "TR"
position (Figure 8) on the back
side of the reel. Align the holes
and install the bolts.
5. Reposition the spring mounting
bracket as shown in Figure 8,
using two 3/8"-16 x 0.75 spinlock
bolts and two 3/8"-16 spinlock
nuts. The reel should look like
Figure 8.
6. Check that all bolts and nuts are
tight.
7. Replace the spring per Hannay
TSB 2013.06.003 Changing a
Hannay Spring Motor.
8. To go from a "TR" to an "SR"
simply reverse steps 1 – 7,
discarding the bolts and nuts
from step 5.
PDF 1-20
"SR" to "TR"
with an "A, B, D, F, G, or SA" Spring:
Figure 7 - Reel with Rollers in the "SR" Position
Figure 8 - Reel with Rollers in the "TR" Position
5 of 7
Form H-1305-TSB Rev 1
Advertisement
