Advertisement
TSB 2013.07.001 : Changing Roller Arm Positions: "N-Series" Spring Reels
Changing Roller Position from
1. Remove spring per Hannay TSB
2013.06.003 Changing a Hannay Spring
Motor, this can be found at www.hannay.
com. The reel should look like Figure 3.
2. Make note of the spring bracket
mounting location so it can be reinstalled
later.
3. Remove the 3/8" nuts and bolts holding
the spring mounting bracket and roller
arms to the frame.
4. Move the Roller Arms to the "TR"
position (Figure 4) on the back side of
the reel. Align the holes and install the
bolts.
5. Reposition the spring mounting bracket
as shown in Figure 4, using two 3/8"-16
x 0.75 spinlock bolts and two 3/8"-16
spinlock nuts. The reel should look like
Figure 4.
6. Check that all bolts and nuts are tight.
7. Replace the spring per Hannay TSB
2013.06.003 Changing a Hannay Spring
Motor.
8. To go from a "TR" to an "SR" simply
reverse steps 1 – 7, discarding the bolts
and nuts from step 5.
PDF 1-20
"SR" to "TR"
with a "J, K, or M" Spring:
Figure 3 - Reel with Rollers in the "SR" Position
Figure 4 - Reel with Rollers in the "TR" Position
3 of 7
Form H-1305-TSB Rev 1
Advertisement
