Tools Needed For Assembly; Verifying Parts; Checking Combination Square; Torx Wrench - Bosch GCM18V-10SD Operating/Safety Instructions Manual

Verifying Parts

Check that you have the tools needed for the as-
sembly of the saw, as shown in Fig. 5.
Fig. 5
Fig. 6
Position
combination
square.
3/4" (19mm)
board with
straight
top edge
16099221PJ GCM18V-10SD OSI 20220506.indd 17

Tools Needed For Assembly

Combination Square
Draw line.

Checking Combination Square

Check that the combination square is true.
1. Position the square and draw a light line as
shown in Fig. 6.
2. Flip the square as shown in Fig. 6.
3. Check the edge of the flipped square against
the drawn line, and make sure there is no
gap or overlap at the bottom end as shown
in Fig. 6.
No gap or overlap.
-17-

Torx Wrench (41)

(supplied)
Flip square here.
5/6/22 11:42 AM