Maserati Ghibli Owner's Manual page 319

To Reconnect the Battery
NOTE:
When the battery cables have been
disconnected and the boot lid has
been locked, it is necessary to pull the
emergency release lever in order to
re-open it. To access the boot and
operate the emergency release fold
the rear seatback (see "Cargo Area"
chapter in section "Understanding the
Vehicle").
CAUTION!
• It is essential when reconnecting
the cables on the battery that the
positive cable is precisely attached to
the positive post (+) and the negative
cable is attached to the negative post
(–).
•
Cable clamps should be tight on the
terminal posts and free of corrosion.
After the battery has been
disconnected and re-connected
and before starting the engine it is
necessary to proceed as follows:
• Unlock and lock the doors using the
key fob.
• Close manually the boot lid, unlock
it with the key fob and then lock
it manually on more time. If the
vehicle is equipped with power boot
lid/Hand Free, manually perform the
complete closure. Then move the lid
automatically, using the buttons on
the lid itself, performing a complete
cycle of opening and closing. If the
limit of maximum power boot lid
opening has been set, it is necessary
to reset it (see "Open and Close
Maintenance and Care
the Boot Lid" in section "Before
Starting").
• Initialise the climate control system
by activating the system and pressing
the "AUTO" control as described in
chapter "Air Conditioning Controls"
in section "Dashboard Instruments
and Controls".
• Turn on the MIA and set the date
and time (see "TFT Display Setting
and Menu Overview" in section
"Dashboard Instruments and
Controls").
• Lift, release and lift again the lever
located behind the shift lever to
inizialize the electric parking brake.
Following this operation, at the next
key cycle, the warning light on
the instrument cluster will turn off
and the error messages regarding the
unavailability of the radar functions
will also no longer be present.
• For correct activation of the approach
lights on the external mirrors, press
at least once the tilt button on the
driver's door panel so that the door
mode recognizes the mirrors position.
• Start the engine and perform the
end-stop learning of EPS, steering
fully to the left and then to the right.
The EPS failure warning light and
message should disappear on the TFT
display.
8
317