Maserati Ghibli Owner's Manual page 140

Dashboard Instruments and Controls
1 st Dimmable position: allows
minimum to maximum
brightness tuning of the in-
strument cluster dials, dis-
play, control switches and
MIA's backlight, including
all displayed messages.
2 Stable position: allows max-
nd
imum brightness set.
3 Stable position: allows to
rd
switch on the main and
reading lights of the front
dome light.
4
The right regulator has 2 different
positions:
0 Stable position: night light-
ing off.
(OFF)
1 Dimmable position: allows
st
minimum to maximum
brightness tuning of the
front dome light LED and
the night lighting.
Multifunction Lever
The multifunction lever is fitted on the
left side of the steering column.
The multifunction lever controls
the operation of the turn signals,
headlight beam selection and
overtaking lights. This lever controls
also the operation of windshield wiper
and washer (for this content see the
138
chapter "Wipers and Washers Control"
of this section).
Turn Signals
Move the multifunction lever all the
way up or down until the stop trigger;
the left or right arrow on respectively
the speedometer and tachometer
instrument cluster, flashes to show
proper operation of the front and rear
turn signal lights.
To activate lane change function, tap
the lever up or down once, without
moving beyond the detent. The turn
signals (right or left) will flash three
times then automatically turn off. This
function is useful when overtaking or
changing lanes.
NOTE:
• If either light remains on and does
not flash, or flashes at a fast rate,
check for a defective outside light.
If an indicator on instrument cluster
fails while moving the lever, then the
turn indicator is probably defective.
• The message that a turn signal is on
will appear in the instrument cluster
and a continuous chime will sound
if the vehicle is driven more than 1.6
km (1 mile) with either turn signal
on.