Maserati Ghibli Owner's Manual page 219

dedicated area. See "TFT Display
Areas" in section "Dashboard
Instruments and Controls".
Displayed information depends on
system status: ready, set, temporarily
cancelled or override.
Activation
To turn the system on, push the
ON/OFF button or the ACC time gap
button for 2 seconds (in the Optional
Configuration). The white light
with below 3 dashes on the TFT display
will illuminate.
To turn the system off, push the
ON/OFF button a second time
or the ACC button (in the Optional
Configuration). The white light
will turn off.
NOTE:
The CC system must be turned off
when not in use.
WARNING!
Never leave the Cruise Control system
on when not in use. You could
accidentally set the system or cause it
to go faster than you want. Always
leave the system off when you are not
using it.
Speed Range of Use
Speed
Minimum 30 (20)
Engaged/activated 30 (20)
Maximum 210 (130)
Setting Desired Speed
Turn on the CC function. When the
vehicle has reached the desired speed
(in the example: 100 km/h), push
downward the multifunction switch
(SET -) and release.
The green light with below the
desired speed will illuminate on the
TFT display.
Driver Assistance Systems
Release the accelerator and the vehicle
will operate at the selected speed.
NOTE:
km/h The vehicle should be travelling at
(mph)
a steady speed and on level ground
before pushing the switch downward.
Pressing the
the ACC time gap button for 2 seconds
(in the Optional Configuration) or
moving the ignition device in OFF
position erases the set speed memory.
Changing Speed Setting
Pushing the multifunction switch
upward (RES +) or downward (SET
-) once, or by holding it down, will
enable to increase or decrease the set
speed by one unit (1 km/h or 1 mph).
If the car is equipped with ADAS
Systems, the single press of the
multifunction switch will increase or
decrease the set speed of 1 km/h or
"ON/OFF" button or
217
6