Table of Contents
Advertisement
INSTALLING YOUR APPLIANCE
Non-pyrolytic underbench ovens and side open door oven
Your underbench oven looks best when the control panel is directly under the benchtop. An upper infill panel may have
to be added if the cooktop placed over the oven is too deep. Refer to cooktop installation instructions for required
clearance between cooktop and oven.
Power point connection for the WVE617 must be accessible with the appliance fully installed. If the supply cord is
damaged it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid
a hazard.
upper infill
(if required)
Pyrolytic underbench oven
Your underbench oven looks best when the control panel is directly under the benchtop. An upper infill panel may have
to be added if the cooktop placed over the oven is too deep. Refer to cooktop installation instructions for required
clearance between cooktop and oven.
WARNING
CAUTION
NOTE: Dimension "D".
A requirement for all pyrolytic clean ovens – for proper ventilation there must be a gap at the bottom rear of the
cabinet. This can be a full width opening 20mm deep.
upper infill
(if required)
44
INSTALLATION
A
B
C
use long black
installation
screws
A
B
558
D
C
use long black
installation
screws
Flush fit
Proud fit
558
mounting
holes
596
A
GAS TYPE
Flush fit
600
Proud fit
565
mounting
holes
596
A
B
600
600
581min
565
590
560min
B
C
600
581min
590
560min
C
D
20
20
Advertisement
Table of Contents
