Table of Contents
Advertisement
GROUP Engine
NUMBER 090
MODEL 2011MY Sedona (VQ), Rio (JB)
DATE February 2011
SUBJECT: DATA COLLECTION: EXTRACT CALIFORNIA EMISSIONS DATA FROM ECU
(DC002)
This bulletin provides information related to extracting "In use performance tracking" missions data
from the engine control unit (ECU) in certain vehicles sold in California. The California Air Resource
Board (GARB) requires this emissions data to be extracted from the ECUs of a number of
customer owned 2011 model year vehicles with a minimum of 3000 accumulated miles without
reprogramming or resetting. To facilitate collection of this data at the dealer level, changes to the
GDS have been made so that screen shots will allow the capture of relevant parameters.
*NOTICE
This data collection does not apply to vehicles or dealers operating outside of California.
*NOTICE
IF THE VEHICLE MEETS THE CRITERIA BELOW, CALIFORNIA DEALERS MUST PERFORM
THIS DATA COLLECTION ON VEHICLES WHENEVER AN AFFECTED VEHICLE IS IN THE
SHOP FOR ANY MAINTENANCE OR REPAIRS.
For vehicles listed on DCS as requiring this procedure, follow the instructions in this bulletin after
confirming that the following criteria are met:
^ WebDCS shows this as an open Data Collection code DC002A-B (depending on model) for the
vehicle.
^ Vehicle has more than 3000 miles on its odometer.
^ Vehicle repair history does not show battery replacement/disconnection/reset or an ECU Update
done in the last 3000 miles, because IUMPR data
would have been cleared by such an event.
^ Vehicle does not have a check engine light ON.
CAUTION
If vehicle meets above criteria, collect data prior to any other campaign or repair-related activities.
Service Procedure:
1. Open the engine compartment and locate the emission label under the hood. Locate and write
down the "Group" number found on the label for later
Advertisement
Table of Contents
