Canon EOS C300 Instruction Manual page 24

Preparing the Power Supply
Attaching the Battery Pack
1 Set the Q switch to OFF.
2 Slide the BATT. OPEN switch in the direction of the arrow and open
24
the battery compartment cover.
3 Insert the battery pack all the way into the compartment as shown
in the illustration and press it gently toward the left until it clicks.
4 Close the battery compartment cover.
Removing the Battery Pack
1 Set the Q switch to OFF.
2 Slide the BATT. OPEN switch in the direction of the arrow and open
the battery compartment cover.
3 Holding down the RELEASE latch, slide the battery pack toward the
right and then pull it out.
4 Close the battery compartment cover.
Checking the Remaining Battery Charge
When the camcorder is turned on, you can check the remaining battery charge by looking at any recording/
playback screen or the [Battery/Hour Meter] status screen (A 160). When the camcorder is turned off, use one
of the following methods to check the approximate remaining battery charge.
Press the CHECK button on the battery pack. An indicator will light for
approximately 3 seconds and show the approximate remaining battery
charge.
0-25%
26-50%
51-75%
76-100%
CHECK button
0 100%
Battery charge indicator