Safety Precautions; Safety Icons; General Safety Precautions; Safety Precautions During Installation - Quincy QOCS 25 Instruction Book

Instruction book
1

Safety precautions

1.1

Safety icons

Explanation
1.2

General safety precautions

1. The operator must employ safe working practices and observe all related local work safety
requirements and regulations.
2. If any of the following statements does not comply with local legislation, the stricter of the
two shall apply.
3. Installation, operation, maintenance and repair work must only be performed by authorised,
trained, specialised personnel.
4. Before carrying out any maintenance, repair work, adjustment or any other non-routine
checks, stop the device. In addition, the power isolating switch must be opened and locked.
1.3

Safety precautions during installation

1. Install the equipment where the ambient air is cool and as clean as possible. Consult section
Reference conditions and limitations.
2. During installation or any other intervention on the equipment or one of the connected
machines, the machines must be stopped, de-energized and the isolating switch opened
and locked before any maintenance or repair. As a further safeguard, persons switching on
remotely controlled machines shall take adequate precautions to ensure that there is no one
checking or working on the machine. To this end, a suitable notice shall be affixed to the
start equipment.
3. Install the equipment in an area free of flammable fumes, vapours and particles, e.g. paint
solvents, that can lead to internal fire or explosion.
4. The electrical connections must correspond to the applicable codes. The equipment must be
earthed and protected against short circuits by fuses in all phases. A lockable power
isolating switch must be installed near the equipment.
5. For machines controlled by a central control system, a sign stating "This machine may start
without warning" must be affixed near the instrument panel.
2920 7197 51
Danger to life
Warning
Important note
All responsibility for any damage or injury resulting from neglecting these precautions, or
non-observance of the normal caution and care required for installation, operation,
maintenance and repair, even if not expressly stated, will be disclaimed by the
manufacturer.
3