Table of Contents
Advertisement
Setting up the scanner
Summary of the Imprinter menu modes and settings
Number, mode and
default display
01 Setting the imprinter data
0 1 . P r e
I m p r i n t
02 Setting the imprinter
start position
0 2 . P r e
P
o s i t i o n
<
0 C h a r >
24
Uses the imprinter to stamp the front sheet of each scanned page
with text you specify.
H o s t
Host
Host: Prints the text specified with the software application on the com-
puter.
Count: Prints according to the counter setting for "Select the counter
displayed on LCD". (Counter menu, mode 01)
Specifies the starting location of the stamp printed by the im-
printer if Count was selected for 01 above.
Press a select arrow key (
1 0 . 0 m m
the stamp will print. If zero is entered, the stamp prints 10 mm from the
top edge of the page.
Example: 2 Letter Text Setting
0 2 . P r e
<
1 C h a r >
The mm setting tells you the approximate distance of the starting posi-
tion from the top of the page.
Enter a text string 0 (10 mm or 0.4 in.) to 72 characters wide (182.8 mm
or 7.2 in.)
Here is an illustration of the example above. The two letters print 14.8
mm (0.6 in.) from the top.
[
[
[
Spaces fill out stamps shorter
than 7 characters.
The count must be printed with 7-digit numbers. Numbers shorter than
7-digits are counted as spaces and not printed.
Content
Count
) to specify the position on the page where
P
o s i t i o n
1 2 . 4 m m
Top of the paper
10mm
14.8mm
(0.4in.)
(0.6in.)
Top of the printout when
[
[
the imprinter start position
[
is set to 2 characters.
Advertisement
Table of Contents
