Calibrating The Paper Sensor - Citizen CT-S801 II User Manual

3.12 Calibr ating the Paper Sensor
Calibrate the paper sensor to suit the actual paper you are using before using
label paper or black mark paper.
When you perform the procedure below, the printer will automatically feed the
paper loaded in it and set the sensor to the optimum sensitivity. Or, the paper
type is automatically selected.
To load label paper
1. Turn off the power.
2. Pull the cover open lever forward and open the pap er cover.
3. Press in on the pap er damper in the directio n indicated by the arrow until it clicks.
4. Peel off the first lab el of the lab el paper.
Peel off a few lab els, if they are short, so at least 5 cm of paper is uncovered.
5. Load the paper roll so that th e printab le side of the pape r is facing down.
6. Adjust the pap er position so the part from which you peeled the label is located
above the label sensor.
Label sensor
7. Close the pap er cover.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
Paper damper
Label
— 39 —
V10 CONSUMIBLES S.L.
Roll paper
Label guide