Remote Control Handset; Inserting Batteries; Switching On/Off; To Switch The Tv On - Akai ALED1906TBK User Manual

Remote Control Handset

Inserting Batteries

• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the batteries from the remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.

Switching On/Off

To Switch the TV On

• Connect the power cord to the 110-240V AC, 50/60
Hz.
• Press STANDBY touch button. Then the standby
LED lights up.
• To switch on the TV from standby mode either:
• Press the "
on the remote control.
• Press the control switch right side of the TV. The TV
will then switch on.
Note: If you switch on your TV via P+ or P- buttons on
the remote control or on the TV set, the programme
that you were watching last will be reselected.
By either method the TV will switch on.

To Switch the TV Off

• Press the "
the control switch on the Tv until shut down , so the
TV will switch to standby mode.
• To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode, the
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.

Input Selection

Once you have connected external systems to
your TV, you can switch to different input sources.
Press "SOURCE" button on your remote control
consecutively for directly changing sources.
Note : YPbPr mode can be used only when you
connect a device that has a YPbPr output through the
PC input with YPbPr to PC cable (not supplied).
English - 54 -
" button, P+ or P- or a numeric button
" button on the remote control or hold