Table of Contents
Advertisement
3. Inserting the Tape Cassette
Make sure your Tape Cassettes display the TZe mark (
Use only tape widths of 3.5 mm, 6 mm, 9 mm, or 12 mm.
If there is a stopper on the TZe Tape Cassette, remove it before installation.
1. Hold the label printer as shown in the
illustration. Open the Cassette Cover
by pressing the mark on its side (1) and
pulling in the direction of the arrow (2).
2. Insert the Tape Cassette following the
drawing marked inside the case.
Confirm that the tape is aimed at the
green Tape Outlet and gently press the
Tape Cassette into the label printer
until it locks into place.
NOTE
• Make sure that there is no slack in the
tape. To fix any slack, pull the end of
the tape out of the Tape Guide.
• When inserting or removing the Tape
Cassette, make sure that the tape
does not catch on the silver pin (3) or
the Print Head.
3. Insert the two hooks at the rear of the
Cassette Cover into the slots on the
label printer (4). Push the Cassette
Cover closed (5), making sure it locks
into place.
).
2
End of Tape
Tape Guide
3
4
Cassette Cover
1
Print Head
5
Advertisement
Table of Contents
