Panasonic Palmcorder PV-23-K Operating Instructions Manual page 22

Playback your Recordings
Your Palmcorder may be connected to a TV to play
back tapes or to monitor what you are recording.
TV with AUDIONIDEO IN Jacks.
To AudioNideo In
Audio/
Video
Cable
(suplied)
To AudioNideo Out
TV without AUDIONIDEO IN Jacks.
To AudioNideo Out
RF Adaptor
(optional)
VCR/TV
Selector
VHF Connecting
Cable
(not supplied)
22
300 ohm-75 ohm
transformer
(not supplied)
or F Connector
UHF Antenna
Playback or Monitor using a
1
Connect your Palmcorder to a power
(Battery Pack, AC Adaptor, or Car
source
Battery cord).
POWER
2
VCR OFF CAMERA
Set the POWER switch to VCR
a tape.
to monitor what your
Or set to CAMERA
Palmcorder is recording.
3
TV
Turn the ON and set it to LINE INPUT.
Check your TV operating instructions for
further information.
Note:
If your TV has no VIDEO or AUDIO IN Jacks,
select CH or 4 on your TV to match the RF
3
Adaptor CH switch and set the VCR/TV
3/4
selector on the RF Adaptor to VCR.
4
Start playback or begin a recording.
To watch TV only
If you have connected the Palmcorder to
your TV using an RF Adaptor:
Set the POWER switch to "OFF"
Palmcorder.
Then, set the VCR/TV Selector on the RF
"TV."
Adaptor to
TV
Now, turn the ON and select a
channel.
TV
to playback
on the