Table of Contents
Advertisement
Only a qualified installer(*1) or qualified service person(*1) is
allowed to undertake work at heights using a stand of 50 cm or
more or to remove the intake grille of the indoor unit to undertake
work.
Wear protective gloves and safety work clothing during
installation, servicing and removal.
Do not touch the aluminium fin of the unit. You may injure
yourself if you do so. If the fin must be touched for some reason,
first put on protective gloves and safety work clothing, and then
proceed.
Do not climb onto or place objects on top of the outdoor unit.
You may fall or the objects may fall off of the outdoor unit and
result in injury.
Before opening the inspection opening, set the circuit breaker
to the OFF position. Failure to set the circuit breaker to the OFF
position may result in injury through contact with the rotation
parts. Only a qualified installer (*1) or qualified service person(*1)
is allowed to remove the inspection opening and do the work
required.
When work is performed at heights, use a ladder which complies
with the ISO 14122 standard, and follow the procedure in the
ladder's instructions. Also wear a helmet for use in industry as
protective gear to undertake the work.
Before cleaning the filter (sold separately) or other parts of the
outdoor unit, set the circuit breaker to OFF without fail, and
place a "Work in progress" sign near the circuit breaker before
proceeding with the work.
Before working at heights, put a sign in place so that no-one will
approach the work location, before proceeding with the work.
Parts and other objects may fall from above, possibly injuring
a person below. While carrying out the work, wear a helmet for
protection from falling objects.
Do not use the refrigerant other than R32 or R410A.
For the refrigerant type, check the outdoor unit to be combined.
The refrigerant used by this air conditioner, follow to the outdoor
unit.
7-EN
The air conditioner must be transported in stable condition.
If any part of the product is broken, contact the dealer.
When the air conditioner must be transported by hand, carry it by
four or more people.
inside the unit. Y
This appliance is intended to be used by expert or trained users
in shops, in light industry, or for commercial use by lay persons.
Selection of installation location
appropriate measures to ensure that the concentration of
refrigerant leakage occur in the room does not exceed the critical
possible. If the gas leak and accumulate around the unit, it may
ignite and cause a fire.
To transport the air conditioner, wear shoes with additional
To transport the air conditioner, do not take hold of the bands
around the packing carton. You may injure yourself if the bands
should break.
shocks if they poke their fingers or other objects into the indoor
unit while the air conditioner is running.
directly exposed to the wind of air conditioner, otherwise it may
cause imperfect combustion.
– 4 –
flammable gas leaks are
fl
EN
ID
ID
8-EN
Advertisement
Table of Contents
