ACDC RAPTOR Installation Instructions And User Manual page 8

Installation procedure
1. Fixing the wall bracket. Fixing the wall bracket to the wall 2cm-15cm over the shaft or
intermediate bracket (depend on the actual installation space).
2. Fixing the steel track to the wall bracket with cotter pin.
3. Sleeve the motor shaft adapter to the motor shaft according to Fig. 5.
Notice: the flanged end facing down.
4. Fixing garage door opener to the track by U bracket A . It‟s enough for 2 Nm fastening force.
5. Fixing the track bracket with U bracket B. Fix the track bracket as closer to the opener as you
can, if there is enough space.
Notice: Make sure the track is horizontal and vertical to the shaft.
6. Fixing the iron angle A to track bracket, hanging the track to ceiling by iron angle A. Make sure
the connection of iron angle A and ceiling is firm enough.
7. Fixing the door bracket on the door panel, fixing the straight arm and bent arm, fixing the clutch
cord.
8. Release the clutch, try to open and close the door by hand. Make sure there is no resistance
between door panel and track.
9. Connecting the opener with power and adjusting the operation.
Notice: Make sure the opener‟s voltage is in accordance with the local voltage. Connect the
opener to a properly earthed power supply.
Fig.6
- 6 -