PRESONUS Eris Sub8 Owner's Manual page 13

3 Tutorials
3.2 LevelCalibration
3. Play pink noise through your speakers.You should not hear anything yet.
通过你的扬声器播放粉红色噪音。你应该还听不到任何声音。
Eris E4.5 Active Speaker
4. Begin slowly increasing the volumeof your left monitor until the acoustic level
of the pink noise reaches 82 dB SPL on your SPL meter when measured at your
listening position.Turnoff your left monitor and repeat with your right monitor.
开始慢慢增加你的左边监听器的音量，直到粉红色噪音的声级在你
的监听位置测量时达到82dB SPL。关掉你的左边监听器，然后重复
你的右边监听器。
If you're using monitors that provide a single level control for both the
left and right side, like the Eris E3.5 or E4.5, play pink noise through both
monitors,increase the volumeuntil your SPL meter reads 85 dB.
如果你使用的是为左右两边提供单一电平控制的监听器，如Eris
E3.5或E4.5，通过两个监听器播放粉红色噪音，增加音量直到你的
声压计读数为 85dB。
PowerUser Tip:If 82 dB or 85 dB is too loud or too quiet for your room, set the level to
one that is more comfortable for your listening requirements.Just be sure to set the
same level for both the left and the right monitor.
用户提示：如果 82 分贝或 85 分贝对你的房间来说太大声或太安静，请将电
平设置为对你的聆听要求更舒适的电平。只要确保左边和右边的监听器设置
为相同的电平。
5. Turnyour full-range monitorsoff.If your Sub8 is connected to the Sub Out on
a speaker with a dedicatedSub Out, set the input volume of your Eris Sub8 to
"0"and skip to Step 7.
关闭你的全音域监听器。如果你的Sub8连接到有专用 Sub Out 的扬
声器上的 Sub Out，将Eris Sub8的输入音量设为 "0 " 并跳到步骤 7。
6. Begin slowly increasing the input volume on your Eris Sub8 until the
acousticlevel ofthepinknoisereaches 79dB SPLonyour SPL meter when
measured at your listening position.
开始慢慢增加Eris Sub8的输入音量，直到粉红噪音的声级在聆听位置测量
时，声压计上达到79dB SPL。
Eris
Owner'sManual
SPL:
82 dB
Sub8
™
11