Hamilton Beach 11550-CCC Manual page 4

Assembly Instructions
1
Unpack all pieces from carton and remove any packing materials. Assemble
steam nozzle holder by pushing it onto the tube end of the retractable pole.
NOTE: Brush and Creasing Attachments are optional accessories on select
models.
4
Assemble steam nozzle holder by
pushing it onto the tube end of the
retractable pole. To extend the
retractable pole, flip each lever on
the pole to the open position.
4
Before First Use:
5
Extend the pole up to full height;
then flip levers closed to secure.
Remove ALL packing materials from garment steamer.
2
Insert base of retractable pole into
opening on top of the steamer, lining
up the cutout notches; then slide the
ridged collar down over the opening.
6
Firmly grasp base of flexible steam hose
and push in tabs on both sides. Insert
into opening on steamer. CAUTION!
Burn Hazard: Escaping steam is hot.
Ensure base of hose is fully inserted as
directed. If steam is leaking around base
of hose, turn off and allow to cool before
attempting to adjust the base of hose.
3
Holding ridged collar on base of
pole, turn clockwise until tight-
ened and secure.
7
Hang steam nozzle/handle on
steam nozzle holder.