FrSky TANDEM X20 Series Manual

FrSky TANDEM X20 HD (UpKit) Manual
Introduction
FrSky Tandem X20 series HD radio system provides the perfect solution for FPV flying and pilots preferring an
easier operation with fewer devices. The HD version of the X20 radio system includes an integrated FPV screen
supporting 720p 60FPS video quality, removing the need for a standalone FPV screen. When combining the HD
720p 60FPS video with near 0ms low latency digital video transmission technology, the X20 HD radio will provide
more enjoyment and confidence when FPV flying tours. The built-in video receiver module is compatible with all
HDZero video transceiver (VTX) products.
The X20 HD radio package includes a 5.8G antenna kit. The circularly polarized directional antennas ensure that
the radio receives optimum video transmission signals, even in complex RF environments. The HD version of the
X20 radio also provides an HDMI output which can be used to easily transfer the HD video to an external monitor
or device if required, this provides a great solution if you wish to use your existing FPV goggles which support
HDMI-in, removing the need for separate HDZero video receiver attached to your goggles.
Layout
2.4G Internal Antenna
Display Screen
Power Switch
SF
SE
SB
SA
Slider
Stick
SYS,
MDL,
MDL
DISP,
RTN
Speaker Custom button
Ventilation hole 900M Internal
Carrying Bar Antenna
Module
Bay
SWJ
SWI
Battery
Cover
FrSky Electronic Co., Ltd. www.frsky-rc.com
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: sales4tech@gmail.com
FrSky TANDEM X20 HD (UpKit) Manual
Gimbal adjustment (UpKit version)
Unscrew the four screws on the back cover of the remote control, open the back cover of the remote control, you
can adjust Gimbal.
Install the screw
Install the screw
Audio bluetooth (UpKit version)
This Audio module can have your wireless Bluetooth audio devices connected and functioned as a broadcast.
Open the wireless settings in the ETHOS system menu, select "Audio" and click "Search", then open your
wireless Bluetooth audio device and bound.
2S Li-battery balance charging via USB-C:
The Green LED indicator states:
Led on: in Charging/Led off: end of charge/flash: charge fault
Battery compartment size: 84*41.5*20mm (L*W*H)
Note: 1. Charge the battery with the USB adapter (Voltage: 5V+0.2V Current:＞2.0A) when you use the
USB charging function.
2. The lower the initial charging voltage, the better the charging effect is when the voltage
difference cells exceed 50 mV between the two.
Navigation Controls
The left navigation control does RTN, SYS, MDL, DISP and Page UP/Down. The right navigation control does
scroll and enter. Both navigation controls and touch screen can be used to control the system.
MDL
ETHOS Operating System
Create the model
Step 1: First go to System Settings, then click Model Select to select the model type.
FrSky Electronic Co., Ltd. www.frsky-rc.com
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: sales4tech@gmail.com
Version
1.0
Switch
● SA: 3 positions; Short Lever
● SB: 3 positions; Long Lever
● SC: 3 positions; Long Lever
● SD: 3 positions; Short Lever
● SE: 3 positions; Short Lever
SH
SG ● SF: 2 positions; Long Lever
SC
● SG: 3 positions; Short Lever
SD
● SH: 2 positions; Momentary, Long lever
Slider
You can choose the Switch and define its
position in the HARDWARE menu.
Stick
1. Micro SD card is not provided with shipment.
2. USB port is for upgrading, reading/writing
Micro SD cards and internal memory of radio
Hook
contents and charging.
3. Smart Port is for firmware upgrade for all
FrSky S.Port devices.
Micro SD Card Port
Type-C USB Port Smart Port
Earphone Port Training port
ANT2 ANT1
Ext. 5.8G Antenna Ext. 5.8G Antenna
HDMI
Contact us: frsky@frsky-rc.com
Version
1.0
Install the screw
Loosen the four mounting
screws, rotate the gimbal to
a suitable Angle, and tighten
the screws.
Contact us: frsky@frsky-rc.com
FrSky TANDEM X20 HD (UpKit) Manual
5.8G Antenna (video transmission)
Peak Gain: 8.0dBi@5.5GHz , 7.0dBi@5.785GHz
Specifications
● Dimension: 213*200*95 mm (L*W*H)
● Weight: 833g (without battery)
● Operating system: ETHOS
● Internal RF module: TANDEM
● Number of Channels: 24 channels
● Operating Voltage Range: 6.5 ~ 8.4V (2S Li-battery)
● Operating Temperature: -10℃~60℃ (14℉~140℉)
● USB Adaptor Voltage: 5V+0.2V
● USB Adaptor Current: >2.0A
● Backlit touchable LCD resolution: 800*480
● Compatibility: ACCST D16 & ACCESS & TD series receivers
● Resolution & Frame Rate of HD VTX: 720P 60FPS
Features
● Built-in near 0ms latency HD digital video transmission system (720P 60FPS)
- Supports working with HDZero VTX Race V2 / Whoop / Freestyle, etc.
(Note: the range is dependent on the VTX power setting in use.)
- Supports HDMI Output (Mini type interface)
- 5.8G circularly polarized directional external antennas
● Built-in TD 900M/2.4G Dual-Band Internal RF Module
Supports Multiple Working Modes
- 2.4G ACCST D16 Mode (Compatible with ACCST Receivers with D16 V2 or later FW)
- 2.4G ACCESS Mode (Compatible with ACCESS Receivers)
- 900M ACCESS Mode (Compatible with ACCESS R9 868/915MHz Receivers)
- Capable of simultaneous working under ACCESS mode
- 2.4G&900M TD Mode (Compatible with TD Receivers)
NEW
● Super-low latency and long-range control with telemetry
- Up to 50 to 100KM range and down to 4ms end-to-end latency
● 800*480 Color Touch-Screen Displays
● 6 Quick-Mode Custom Buttons (Front) and 2 Momentary Buttons (Rear)
● Lite Type External Module Bay
● Built-in 6-axis Gryoscope Sensor
● All CNC Metal Trim Knobs
● Haptic Vibration Alerts and Voice Speech Outputs
● Supports Recharge System for 2S Li-ion Battery (USB Type-C Interface)
● High-speed PARA Wireless Training System (Compatible with FreeLink App3.0)
● High-Precision Hall-Sensor Gimbals with All-CNC Metal Panel
● ETHOS: The more powerful, Flexible and Intuitive OS for your radio.
- Clear and Intuitive UI Design
- Supports Dual Operation Modes of Radio Display (Touch and Non-Touch)
- Supports Multi-Language Switching
- Hardware/Software Version and Factory Version Detection
- Supports running LUA Scripts
FrSky Electronic Co., Ltd. www.frsky-rc.com
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: sales4tech@gmail.com
FrSky TANDEM X20 HD (UpKit) Manual
Step 2: Configure the model channel and create the model name.
Model Setup Procedure-Internal Module
Step 1:
Step 2: Set the Channel Range
The TANDEM RF module supports 24 channels. the channel range is configurable, and it needs to be double
checked before use.
Range Check
FrSky Electronic Co., Ltd. www.frsky-rc.com
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: sales4tech@gmail.com
Contact us: frsky@frsky-rc.com
Touch the screen or use the navigation keys to enter the
RF system menu.
Contact us: frsky@frsky-rc.com
Version
1.0
Version
1.0