Select a value that is close to the length
of cable normally used.
OFF / 1m(3ft) / 1.5m(5ft) / 2m(7ft) /
3m(10ft) / 4.5m(15ft) / 6m(20ft) /
7.5m(25ft) / 9m(30ft) / 12m(40ft) /
15m(50ft) / 18m(60ft) / 21m(70ft) /
24m(80ft) / 27m(90ft) / 30m(100ft)
4
Select [Set].
This completes the configuration, and
the main screen appears again.
Tip
The cable tone generator will be applied
before the equalizer.
Configuring the equalizer
Configure the equalizer. Under factory
default settings, the equalizer is set to 0 dB
for each frequency and the function itself is
set to [OFF].
1
In the [Setup] screen, select [Audio
Setup].
The [Audio Setup] screen appears.
2
Select [Equalizer].
The [Equalizer] screen appears.
3
Select [ON] to enable the equalizer
function, or [OFF] to disable it.
If you select [ON], the equalizer
settings screen appears.
If you select [OFF], configuration is
complete and the main screen appears
again.
16
Receiver Settings
4
Select the frequency for which you
want to adjust the level, and adjust the
setting.
5
Select [Set].
The setting value is saved.
To cancel the setting, press the ESC
button.
Configuring the transmitter
muting function for the output
connectors
You can select whether to enable the
muting function controlled by the
transmitter for the audio output of each
output connector. The factory default
setting is [To Balanced & Main Only].
1
In the [Setup] screen, select [Audio
Setup].
The [Audio Setup] screen appears.
2
Select [TX Muting].
The [Apply TX Muting] screen
appears.
3
Select the connectors for which you
want the muting function enabled.
Screen
To All
display
Outputs
Connector
BALANCED
OUTPUT
UNBALANCED
OUTPUT MAIN
Enabled
UNBALANCED
OUTPUT AUX/
TUNER
This completes the configuration, and
the main screen appears again.
To
To AUX/
Balanced
Tuner
& Main
Only
Only
–
Enabled
–
–
Enabled