Table of Contents
Advertisement
2. Press "STOP
indicated on the display if an error is found. If several errors are
found, a respective indication is displayed when "STOP
DEMO" button is pressing repeatedly. (e.g. H01
If no error is found, only "T " indication is displayed and remains
unchange even if "STOP
11.5. Displaying Self-Diagnostic Results
<Cassette Deck Section> (H01, H02, H03, F01, F02)
1. Enter the self-diagnostic mode, following the instructions
described in [11.2. Entering Self-Diagnostic Mode].
2. Insert a normal-positioned music tape with erase prevention
niches on both Sides A and B. Press [TAPE
activate the TPS operation so that the tape automatically stops at
an interval between music selections.
3. Press [STOP
remote controller. (Recording does not start.)
4. Then, insert a Cr02-positioned blank cassette tape with an erase
prevention niche of Side A or B set to the left side.
5. Press [
automatically stop after two seconds.
6. Remove the cassette tape, and set the other side.
7. Press [
automatically stops after two seconds.
8. Press [STOP
If an error is found, a self-diagnostic key appears on the display.
If several errors are found, the display shows these keys when
[STOP
/-DEMO] button is pressed repeatedly. (Ex.: H01 - H02 -
F01 - H01)
If no error is found, only the message, "CD TEST" appears on the
display.
/-DEMO" button. A symbol of self-diagnostic is
/-DEMO] and [TAPE
/FF/
] button. The tape will be forwarded and
/REW/
] button. The tape will be rewound and
/-DEMO] button on the unit.
/-DEMO" button is pressed.
] buttons together on the
74
/-
CD F15
F01)
] button to
Advertisement
Table of Contents
