Table of Contents
Advertisement
1. Turn off by pressing power SW in the body.
2. Unplug AC power cord after the indication of [GOOD-BYE], then
disassemble the body.
3. Disassemble the body, and take out CD loading mechanism.
4. Perform disassembly according to the following procedure for
disassembly.
9.23. CR16 mechanism disassembly procedure
9.23.1. Gear for servicing information
- This unit has a gear which used for checking items (open/close of
disc tray, up/down operation of traverse unit by manually) when
servicing. (For gear information, that is described on the items for
disassembly procedures.)
- For preparation of gear (for servicing), perform the procedures as
follows.
- In case of re-servicing the same set, the " gear for servicing" may
be took off because it had been used. So, the "gear for servicing"
must be stored.
1. Remove the gear attached to top cover of CD loading mechanism.
2. Insert the hexgonal wrench (2.5mm) into the gear.
33
Advertisement
Table of Contents
