Channel Master 960 I Instruction And Assembly Manual page 7

FEED AND FEED LEG INSTALLATION
NOTE: Long formed end of Side Feed Leg attaches to
the Reflector rim, short formed to side of Feed Support
Terminal.
Assemble Bottom Feed Leg to bottom of Reflector rim.
From the inside of Reflector rim, insert M6 x 16mm Hex
Bolt thru hole in rim and attach Bottom Feed Leg.Secure
with Lock Washer and Hex Nut.
NOTE: Bottom Feed Leg is the one with slight bend, with
lance, on one end, and is shorter than the Side Feed
Legs.
Leave all hardware loose. Insert Bottom Feed Leg end
with lance into socket hole in center of Feed Support
Terminal. Twist to engage lances. Attach left and right
Feed Support Legs to Feed Support Terminal, securing
with M6 x 16mm Hex Bolts and Lock Washers. Refer to
I n s t ruction for Feed Assembly to assemble Fe e d
Assembly and ODU to Terminal Block. Tighten and
torque all hardware to Te rminal Block and Reflector to
4 ft-lbs (5.4 N-m). Tighten two screws in Terminal Block
socket equally.
FEED AND FEED SUPPORT TUBE INSTA L L AT I O N
MEDIUM DUTY
Assemble "U" Clip to bottom of Reflector using M6 x
22mm Round Head Square Neck Bolt, Lock Washer and
Hex Nut. Insert bottom Feed Support Tube into "U" Clip
and secure with M6 x 55mm Round Head Square Neck
Bolt and elastic Lock Nut. (Ref. Fig. 1.5 & 1.6) Assemble
Feed Support Block (supplied with Feed package) to
Feed SupportTube, using two M6 x 16mm Hex Bolts and
Lock Washers.
96cm System (Ref. Fig. 1.5)
Attach Side Feed Legs and Braces to left and right
sides of Reflector using M6 x 20mm Hex Bolts, Lock
Washers and Hex Nuts. (NOTE: Long formed end of
Feed Leg attaches to Reflector. Short formed end of
Brace attaches to inside of Reflector rim.) Attach flat-
ten end of Brace to top of Mount Housing using M6 x
22mm Round Head Square Neck Bolts, Tooth Lock
Washers, Flat Washers and Hex Nuts. Round Head
Square Bolt fits on the underside of Mount Housing
top, flatten end of Brace on top side of Mount
Housing, Tooth Lock Washer on top of flatten end of
Brace, then Flat Washer and Hex Nut.
Attach Side Feed Legs to support Block using M6 x
20mm Hex Nuts and Lock Washers. Leave all hard-
ware loose.
ASSEMBLY AND INSTALLATION
FIG. 1.3 - Installation of Extension Plate to AZ/EL
FIG. 1.4 - Installation of Feed/Feed Support Legs
FIG. 1.5 - Installation of Feed/Feed Support Legs
Housing (1.2m medium Duty Only)
to Antenna (Light Duty, 96cm Shown)
to Antenna (96cm Medium Duty) 6