Installing The Pedestal - Maytag XHP1000XW Installation Instructions Manual

2.
Washer transport bolts
Locate the transport bolts on rear of washer. Transport bolts
must remain in washer while pedestal is installed. When laying
the washer on its back, hold the base down on the floor. Do
not remove the plastic film, corner posts, or top cap.

INSTALLING THE PEDESTAL

Follow these instructions to install the pedestal on a washer
or dryer.
1.
locate spacer pads
Make sure that all four spacer pads are in place on the top
of the pedestal. Spacer pads reduce vibration between the
pedestal and the washer/dryer.
note: If your washer/dryer has feet installed, remove them.
4
2.
Prepare the washer/dryer
Washer Bottom
Partially install two of the #12 x 5/8" hex-head sheet metal
screws in the lower holes. Leave a space of about 3/8" (10 mm)
between the screw head and the bottom of the washer/dryer.
3.
attach the pedestal
Move the pedestal against the washer/dryer bottom. Slide
the pedestal's keyhole slots over the lower two partially
installed screws.
4.
Secure the pedestal
Position the pedestal toward the front of the washer/dryer and
install the two remaining hex-head sheet metal screws. Do not
tighten completely.
Dryer Bottom