Download Print this page

Complete The Installation - Maytag XHP1000XW Installation Instructions Manual

Pedestal for use only with front load washers and dryers
Hide thumbs

Advertisement

5.
align sides of pedestal
Align the sides of the pedestal so that they are even with the
sides of the washer/dryer. Reach inside the pedestal opening
and securely tighten all four pedestal screws.
6.
Prepare pedestal feet
The pedestal arrives with the feet tight against the bottom
of the unit. Using a 1/4" hex-head ratchet or open-end
wrench, lower the feet approximately 1" (25 mm) away
from the bottom of the pedestal.
7.
Stand the washer/dryer upright
Tip the washer/dryer back to its upright position. Remove
and discard any remaining packaging material.
8.
Follow the installation instructions that came with your model
to finish installing or reinstalling your washer/dryer (i.e., hoses,
vents, etc.).
1"
note: Be sure to remove the transport bolts from the back
(25 mm)
of the washer.
9.
Place a level on top edges of washer/dryer, checking each
side and front. Rock washer/dryer back and forth to make
sure all four feet make solid contact with floor.
If not level, adjust pedestal feet up or down, repeating as
necessary.

COMPLETE THE INSTALLATION

move close to final location
Check levelness
of washer/dryer
Place level here
Not Level
leVel
Not Level
5

Hide quick links:

Advertisement

loading

  Related Manuals for Maytag XHP1000XW