Sharp AQUOS 4T-C60AL1H Operation Manual page 58

Network function
Network setting
Select TV setup on the smart home,and then press
OK. Press to select "Network", and then
/ / /
press OK . It displays the connect information.
Wireless network connection
You can select "Wi-Fi" to connect the network.
When adjust "Wi-Fi" to "On", it displays the nearly
wireless network.
If the current network connection security is not
open, you should enter the password from software
keyboard by pressing OK on the remote control.
Add network
You can add unbroadcast wireless network manually.
Enter the information about the unbroadcast wireless
network , and then select "Connect". Now the
TV is connected to the unbroadcasted wireless
network.
Ethernet network connection
You can select "Ethernet" to connect the network.
Manual connection
You can setup IP address, Subnet mask,Gateway,
First DNS and Second DNS following the on-screen
instructions.
DHCP
System will attempt to obtain IP address and other
information automatically.
Bluetooth
®
Select the "Bluetooth" and then press OK, the TV is
scanning Bluetooth devices.
If you want to connect to the Bluetooth device, please
refer to the screen reminder.
NOTE
• The Bluetooth device may not operate properly depending
on the device being used.
Device name
Set the name for this TV.
You can choose from "My SHARP TV(012345)",
"Bedroom","Second bedroom","Living room",
"Study","Office","Custom".
Network info
Check the information for Internet connection.
25