Sharp AQUOS 4T-C60AL1H Operation Manual page 51

Preparation
Turning the TV on/off
Running the TV for the first time
After inserting the AC cord, the TV is in standby.
Press (POWER) on the remote control or on the TV:
• TV is switched on.
• You can switch the TV to standby by pressing
on the remote control .
Turning off the TV
If the TV is switched on, press
remote control :
• TV is switched into standby and the image disappeared.
• Press (POWER) on the remote control to turn on the TV.
• If you want to turn off the TV from standby, please pull out
the AC cord.
NOTE
• If you are not going to use this TV for a long period of time,
be sure to remove the AC cord from the AC outlet.
• A small amount of electric power is still consumed even the
TV is in standby mode.
• If the TV loses power in special circumstances (such as
power outage or grid fluctuations, etc.), it may not work
well when it is switched on again. Please try to power
off the TV (by the (POWER) on the remote control) or
unplug and replug the AC cord to restart the TV.
• It is a normal phenomenon when the TV temperature rises
in the process of watching TV.
• Please do not cut off the power casually in the process
of switching on or switching off the TV, running APPS or
updating, otherwise TV system could not work correctly.
Please turn off the TV after closing all APPS.
18
User Guide
When the TV powers on for the first time after
purchase, the setting wizard appears. Follow the
menus and make the necessary settings one after
another.
Confirm the following before turning on the
(POWER)
power
• Is the antenna cable connected?
• Is the AC cord plugged in?
Press
(POWER) on the
• It displays the boot screen , and then "Language
Setting" appears.
• It may cost a little time when TV is switched on for
the first time. Please wait patiently.
You can select the Language Setting among the " 繁體
中文", " 简体中文" or "EN" .
Please select "Home" when you watch TV at home.
• "Home": "STANDARD" will be the default value for the
"Picture mode" setting.
• "Store": "Store" is only for retail store displays. " Bright "
will be the default value for the "Picture mode" setting.
You can select "Ethernet" or "Wi-Fi" to connect the
network.
Please see page 24 to 25.
(POWER) on the TV.
Language Setting
Please Select The Environment
Network Setting