Cleaning And Care - Sharp SMO1461GS Operation Manual

CLEANING AND CARE

Be sure the microwave oven CONTROL LOCK feature
is ON before cleaning. See page 20 for instructions on this
feature.
EXTERIOR
The outside surface is precoated stainless steel, glass and plastic.
Clean the outside with mild soap and water. Rinse and dry with a
soft cloth. Do not use any type of household or abrasive cleaner.
STAINLESS STEEL SURFACE
The exterior should be wiped often with a soft damp cloth and
polished with a soft dry cloth to maintain its beauty. There are
also a variety of products designed especially for cleaning and
shining the stainless exterior of the oven. We recommend that
the cleaner be applied to a soft cloth and then carefully used
on the stainless exterior rather than sprayed directly on to it.
Follow package directions carefully.
DOOR
Wipe the window on both sides with a soft damp cloth to remove
any spills or spatters. Metal parts will be easier to maintain if
wiped frequently with a soft damp cloth. Avoid the use of spray
and other harsh cleaners as they may stain, streak or dull the
oven surface.
CONTROL PANEL
Be sure CONTROL LOCK is ON. See page 20 for information
on this feature. Wipe the panel with a cloth dampened slightly
with water only. Dry with a soft cloth. Do not scrub or use any
chemical cleaners. Close the door and turn CONTROL LOCK
off if finished cleaning.
INTERIOR
Cleaning is easy because no heat is generated to interior surfaces
of the oven, so spills and splatters are not baked in. To clean
interior surfaces, wipe with a soft, damp cloth. For heavier soil,
use mild soap and wipe clean with a soft, damp cloth. Never use
abrasive or harsh cleaners or chemical oven cleaners.
Note: Never use metal scouring pads to clean the microwave
oven as pieces may break off the pad and cause electric shock
if they come in contact with electrical parts.
WAVEGUIDE COVER
DO NOT REMOVE THE WAVEGUIDE
ATTENTION
COVER.
The waveguide cover, located on the right side of the interior
cavity, is made from mica, so it requires special care. Keep
the waveguide cover clean to assure good microwave per-
formance. Carefully wipe with a soft, damp cloth any food
spatters from the surface of the cover immediately after they
occur. Built-up splashes may overheat and cause smoke or
possibly catch fire.
E
ODOR REMOVAL
Occasionally, cooking odor may remain in the microwave
oven. To remove odor, combine 1 cup water, grated peel and
juice of one lemon and several whole cloves in a 2-cup glass
microwave safe measuring cup. Boil for several minutes using
100% power. Leave in the microwave oven until water cools.
Wipe interior with a soft cloth.
TURNTABLE AND TURNTABLE SUPPORT
The turntable and turntable support can be removed for easy
cleaning. The turntable can become hot during cooking. Let it
cool before cleaning to prevent the glass from breaking.
The turntable and turntable support can be washed in a
dishwasher in the upper rack or by hand with mild, sudsy
water. Use a mild cleaner and non-abrasive scouring sponge
for stubborn stains.
Note: The turntable motor shaft in the oven is not sealed. Excess
water or spills must be wiped up immediately.
THE EXHAUST FEATURE
The exhaust hood feature is equipped with two grease filters.
When the Vent fan is operated, air is drawn up through the
filters and then discharged through the venting to the outside
or recirculated through the charcoal filter if not vented to the
outside.
Note: Never operate the fan or oven without the filters in place.
REUSABLE GREASE FILTERS
The reusable grease filters should be cleaned at least once a
month. In situations where flaming might occur on surfaces
below the hood, filters will stop the entry of flames into the unit.
TO CLEAN GREASE FILTERS:
1. Turn CONTROL LOCK ON.
2. Pull down gently on the tab toward the front of the oven and
remove the filter. Repeat for the other filter.
3. Soak the filters in a sink or pan filled with hot water and
detergent. DO NOT use ammonia or products with ammonia,
as this will darken the metal.
4. Use light brushing if necessary to remove any embedded dirt.
5. Rinse thoroughly and shake dry to remove moisture before
reinstalling.
6. Replace the filters into the openings.
7. Turn CONTROL LOCK OFF to use the oven.
22