Craftsman CMCL090 Instruction Manual page 8

English
INTENDED USE
This hood light is designed for lighting applications.
DO nOT use in presence of flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
OPERATION
Installing and Removing the Battery Pack
(Fig. B)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
5
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button and firmly pull the battery pack out of the tool
6
handle. Insert it into the charger as described in the charger
section of this manual
Fig.B
6
Power ON/OFF Button (Fig. A)
To turn the light on, press the power button
setting is high mode, press the button again and the light
will convert to low mode, press again to turn the light off.
Low Battery Indicator (Fig. A)
As the battery 4 nears a fully discharged state, the light will
blink twice and then dim, dropping the brightness of the
light below the normal level. The light will continue to blink
twice every 45 seconds until the battery is fully discharged
at which time the light will turn off. Indication time will vary
based on battery pack capacity.
Attaching Hood Light to Auto Hood (Fig. C)
Unfold the hood light and attach the hook
the light to the hood of the automobile, then carefully pull
on the other hook so that it extends out from the housing.
Once the hooks extends past the edge of the hood, slowly
allow the hook to slide back into the housing (do not release
the hook) until it attaches to the hood of the automobile.

CAUTION: Ensure area between extended hook and
hood light is clear before releasing hook. Keep your
fingers out of the area between the hook and the light
when it retracts.
6
into the tool handle, align the
5
, this initial
2
on one side of
1
nOTE: Before installing on hood, make sure
hood is properly secured in the open position via
manufacturer's recommendation.
Fig. C
Adjusting the Orientation of the Light (Fig. A)
Once attached to the automobile hood, the light can be
rotated to the desired position. The rotating mechanisms
are located in the base of each hook
Hood Light Storage (Fig. D)
The hood light folds down for storage. Ensure center joint is
clear of obstruction before folding. To secure folded hood
light, align tab to receiver
6

CAUTION: Keep fingers clear of center hinge when
opening or closing hood light.
Fig. D
MAINTENANCE
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
1
1 .
until they snap together.
7
7
6