Advertisement
Assembly instructions | LK Webserver
Connecting the communication bridge
2
via two webservers
It is possible to create a wireless communi-
cation bridge between the receiver of the
floor heating installation and a network
socket with internet access.
An example of a system with a webserver as a communication
bridge. The webserver is connected to both the water safety sys-
tem and room temperature control ICS.2.
7. Mount the other webserver near a network
socket.
8. Connect the cable from the mains adapter to
the input Power 5 V DC input on the web-
server, connect the mains adapter to a wall
socket.
9. Connect the network cable between the
webserver's ethernet-connection and a net-
work socket with internet access.
10. On the webserver connected to the receiver,
press and release the red button. The LED
lamp will begin to blink.
Within three minutes, press and release the
red button on the webserver connected to a
network socket.
Thecommunication bridge settings are done
in the tab Network in the webserver's user
interface, channel 6 is normally used.
Connecting LK Master Unit WSS with
3
LK Webserver
11. The LK Master unit WSS communicates
wirelessly with the webserver connected to
the network socket with internet access.
12. Connect the cable from the mains adapter to
the input Power 5 V DC input on the web-
server, connect the mains adapter to a wall
socket.
13. Connect the network cable between the
webserver's ethernet-connection and a net-
work socket with internet access.
EN.33.C.190.1709
2 (7)
14. Programming the webserver is carried out
by simultaneously pressing the Open and
Timer buttons on the Master Unit for 2
seconds (the radio symbol begins flashing).
After that press and release the red button
on the webserver (the right LED flashes
red). When the connection is established,
the right LED will show a red solid light for
a few seconds.
Web interface in the LK Webserver
1. Go to the homepage below on a computer
connected to the Internet or mobile device
https://my.lk.nu
If the webserver does not have internet ac-
cess, continue to point 9.
QR code for the login page.
2. Click on Register new user
Log in, new user
3. Fill in the email address, chosen password
and your name. Click on Register new user.
Register new user
Advertisement
