HP Compaq dc7700 MT Hardware Reference Manual page 51

b. To insert the new battery, slide one edge of the replacement battery under the holder's lip with
the positive side up. Push the other edge down until the clamp snaps over the other edge of
the battery (2).
Figure B-2
Type 3
a. Pull back on the clip (1) that is holding the battery in place, and remove the battery (2).
b. Insert the new battery and position the clip back into place.
Figure B-3
NOTE
procedure.
8. Replace the computer access panel.
9. Plug in the computer and turn on power to the computer.
10. Reset the date and time, your passwords, and any special system setups using Computer Setup.
Refer to the Computer Setup (F10) Utility Guide on the Documentation and Diagnostics CD.
11. Lock any security devices that were disengaged when the computer access panel was removed.
ENWW
Removing and Replacing a Coin Cell Battery (Type 2)
Removing a Coin Cell Battery (Type 3)
After the battery has been replaced, use the following steps to complete this
45