HP Compaq dc7700 MT Hardware Reference Manual page 38

9. Connect the power cable (1) and data cable (2) to the rear of the optical drive or diskette drive.
Figure 2-20
10. If you are installing a new drive, connect the opposite end of the data cable to the appropriate
system board connector.
NOTE
SATA connector on the system board labeled SATA1. Connect a second optical drive to the
orange SATA connector labeled SATA3.
If you are installing a diskette drive, connect it to the connector on the system board labeled
FLOPPY P10.
If your are installing a media card reader, install the PCI card included with the media card
reader and connect the USB cable from the media card reader to the USB connector on the
PCI card.
11. Remove the appropriate bezel blank from the subpanel inside the front bezel. See the
Bezel Blanks
12. Replace the front bezel and computer access panel.
13. Reconnect the power cord and turn on the computer.
14. Lock any security devices that were disengaged when the computer access panel was removed.
15. Reconfigure the computer, if necessary. Refer to the Computer Setup (F10) Utility Guide on the
Documentation and Diagnostics CD for instructions about using Computer Setup.
32 Chapter 2 Hardware Upgrades
Connecting the Drive Cables (Optical Drive shown)
If you are installing a SATA optical drive, connect the first optical drive to the white
section for more information.
Removing
ENWW