HP Compaq dc7700 MT Hardware Reference Manual page 50

5. Remove the computer access panel.
CAUTION
right of the DIMM sockets. If the LED is illuminated, the system still has power. Turn off the
computer and remove the power cord before proceeding.
6. Locate the battery and battery holder on the system board.
NOTE
to gain access to the battery.
7. Depending on the type of battery holder on the system board, complete the following instructions
to replace the battery.
Type 1
a. Lift the battery out of its holder.
Figure B-1
b. Slide the replacement battery into position, positive side up. The battery holder automatically
secures the battery in the proper position.
Type 2
a. To release the battery from its holder, squeeze the metal clamp that extends above one edge
of the battery. When the battery pops up, lift it out (1).
44 Appendix B Battery Replacement
After removing the access panel, look for the LED on the system board to the
On some computer models, it may be necessary to remove an internal component
Removing a Coin Cell Battery (Type 1)
ENWW