Canon PowerShot G6 User Manual page 42

Using the LCD Monitor (continued)
...
Fold the LCD monitor back
against the camera body.
• Fold it until it clicks into place against the
camera body. If it is not fully closed, the
image will appear reversed and icons and
messages will not display.
• Icons and messages will appear and
images will show properly (not reversed)
when the LCD monitor is folded right
against the camera until it clicks.
@iIo.@8~e59.$'IiI'S*we@f,jl\ll
~
• In Playback mode, images do not appear reversed. Also, icons
CjJ
and messages always show properly.
Switching between Display Mode
Each time you press the
DISPLAY
button the
LCD
monitor cycles to
the next information mode.
• Shooting Mode
Each time you press the
DISPLAY
button the information view
switches as follows.
On (No Information) ---. On (Information View)* ---. Off
t
I
*
Depending on the LCD monitor's position, the information view may not
display.
' ! i I $ $ I i \ $ < \ } ( , I , < @ e @ @ $ @ I O O l ' ! l @
• You can check detailed information about the image you just
shot without switching the camera to Playback mode. To do so,
while the image is being reviewed on the LCD monitor right after
being taken, press the SET button or
*
button, then DISPLAY
button.
• The display mode is memorized when the camera is turned off. It
assumes the last mode when it is turned on again. When the
LCD monitor is used for shooting and the low battery icon
~
appears, however, the LCD monitor may not automatically turn
on the next time the camera is started.
• Setting the mode dial to
c::QI
or ~~ turns on the LCD monitor
regardless of whether it is set to on or off.
34